8x85 RGB whit 1 Chip?

Post here to discuss the 8x85 RGB LED POV Display.

Moderators: Chuckt, Garth, bitfogav

Post Reply
selnesl
semi-newbie
semi-newbie
Posts: 11
Joined: Thu May 06, 2010 4:40 am
Location: Trondheim, Norway

8x85 RGB whit 1 Chip?

Post by selnesl » Fri Mar 11, 2011 5:32 am

Hi guys...
if im not wrong, think i read some where that u was trying to make a pov whit just 1 pic??
did it work?? :roll:

Lars Selnes Norway

User avatar
brad
Site Admin
Site Admin
Posts: 2576
Joined: Fri Mar 26, 2010 10:30 pm

Re: 8x85 RGB whit 1 Chip?

Post by brad » Fri Mar 11, 2011 12:49 pm

Yes,

I have written up an instructable that you can find here:

http://www.instructables.com/id/The-One ... ith-conve/

And here's a youtube video:


selnesl
semi-newbie
semi-newbie
Posts: 11
Joined: Thu May 06, 2010 4:40 am
Location: Trondheim, Norway

Re: 8x85 RGB whit 1 Chip?

Post by selnesl » Sat Mar 12, 2011 11:06 pm

thats so cool.. nice job mr. :D

User avatar
brad
Site Admin
Site Admin
Posts: 2576
Joined: Fri Mar 26, 2010 10:30 pm

Re: 8x85 RGB whit 1 Chip?

Post by brad » Mon Mar 14, 2011 8:46 am

Thanks!

selnesl
semi-newbie
semi-newbie
Posts: 11
Joined: Thu May 06, 2010 4:40 am
Location: Trondheim, Norway

Re: 8x85 RGB whit 1 Chip?

Post by selnesl » Thu Mar 17, 2011 7:47 am

about the hall effect sensor.. i see on google that there are 2 types of them. one whith 3 legs and on whit 4...
is it the one whit 4 thats the one to use.. and are there one kind u like best.. im shoping parts on ebay.

User avatar
brad
Site Admin
Site Admin
Posts: 2576
Joined: Fri Mar 26, 2010 10:30 pm

Re: 8x85 RGB whit 1 Chip?

Post by brad » Thu Mar 17, 2011 10:51 am

Either should be fine.

I think the one with four legs just has an enable pin. so you can choose to enable or disable the sensor.

With my circuit, I always have the sensor enabled by connecting it to vcc with a resistor.

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests