Audio amp based on TDA2003

[odessa]

Hi all...


Me again

Ok... heres my amp project !!!

I am amazed by the tiny amount of components needed and also by the quality too... a fantastic little chip...plus it runs fine on a 9v battery too !!

Done in Eagle

schem.png (6.4 KiB) Viewed 12215 times

Ready to be printed and etched

board.png (15.44 KiB) Viewed 12215 times

Finished product

1.jpg (66.75 KiB) Viewed 12215 times

2.jpg (64.6 KiB) Viewed 12215 times

This one was done using the Toner Transfer method, great for small boards

3.jpg (64.83 KiB) Viewed 12215 times

[bitfogav]

Im impressed!, thats a neat little project.

Do the heat sink get hot or warm at all Jay?

[odessa]

Hi Gav,

Thanks I must say again I'm amazed at the quality, the vid does it no justice

It did get very hot with a smaller heatsink running off my bench PSU, drew about 1/2 amp at 9v. Running on the little 9v supply with that sink ( stolen from an old laser printer ) it's cold to touch.

[brad]

fantastic project and very nice finished product

[odessa]

Thx

The next stage is to build another identical one, get a dual gang pot and an Ipod line in/charge desk stand thing.

Then I'll have a stereo ipod dock that will charge too.

I think I'll make the cabinet out of wood and make it look old fashioned ... maybe oak

[brad]

A well made wood cabinet can look fantastic!