flashing rainbow schematic, instructables?

Post here to discuss the PIC microcontroller tutorials.

Moderators: Chuckt, Garth, bitfogav

Post Reply
nodoubtman
Can't get enough of electronics!
Can't get enough of electronics!
Posts: 76
Joined: Wed Jan 25, 2012 2:54 am

flashing rainbow schematic, instructables?

Post by nodoubtman » Fri Apr 13, 2012 4:24 am

Hello Brad! :)

Would you mind to post the schematic for this project?
:D http://www.instructables.com/id/The-nig ... /?ALLSTEPS

thank you very much!
marC:)

User avatar
brad
Site Admin
Site Admin
Posts: 2576
Joined: Fri Mar 26, 2010 10:30 pm

Re: flashing rainbow schematic, instructables?

Post by brad » Tue Apr 17, 2012 6:08 am

I didn't have a schematic for it but it's quite simple - the LED just connects the three anodes to PORTB 1, 2 and 3 (each one through their own resistor of about 150 ohms) then the cathode of the led goes to ground. Thats it!

User avatar
bitfogav
Moderator
Moderator
Posts: 908
Joined: Sun Mar 28, 2010 9:03 pm
Location: United Kingdom
Contact:

Re: flashing rainbow schematic, instructables?

Post by bitfogav » Tue Apr 17, 2012 10:35 pm

Looks simple to me, I would say use 100ohm resistors if your using a 3volt battery :)
Schemat123.jpg
Schemat123.jpg (34.11 KiB) Viewed 5139 times

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests